PENGUKURAN LAJU KERUSAKAN DENGAN MENGINDIKASIKAN NILAI MTBF DALAM MANAJEMEN PERAWATAN MESIN PADA PT. AIC
DOI:
https://doi.org/10.55606/jtmei.v1i3.491Keywords:
historical data, maintenance, MTBF, reliabilityAbstract
PT. AIC uses a manual system in engine maintenance management. This makes it difficult to access in measuring the rate of damage, for acceleration information in maintenance management. This problem requires an identification to provide an effective machine maintenance management information system. The MTBF value will be able to detect machine damage, especially the piccanol gamma loom machine. The MTBF value can see the damage to the machine by looking at the condition of the machine, the data history of machine damage, the number of machine failures that occurred in a certain period. The MTBF value of the machine can control the reliability and know the life of the machine. Action maintenance can be done before the machine is damaged. After calculating the MTBF value of the piccanol gamma loom machine, it is still relatively small so the machine is still often damaged.
Downloads
References
H. Al Fata, Analisis dan perancangan sistem informasi untuk keunggulan bersaing perusahaan dan organisasi modern. Yogyakarta: Penerbit Andi, 2007.
D. Daulay I, N, “JURNAL EKONOMI Volume 21, Nomor 4 Desember 2013,” J. Ekon., vol. 21, no. 4, pp. 1–18, 2013.
M. S. Ir. Fajar Kurniawan, Teknik dan Aplikasi Manajemen Perawatan Industri. Yogyakarta: Graha Ilmu, 1st ed. Yogyakarta: Graha Ilmu, 2013.
I. Sodikin, “Analisis penentuan waktu perawatan dan jumlah persediaan suku cadang rantai garu yang optimal,” J. Teknol., vol. 3, pp. 44–52, 2010.
A. Firmansyah, K. Siregar, and T. Sinaga, “Analisis Waktu Antar Kerusakan Mesin Electric Motor Menggunakan Metode Failure Finding Interval (Studi Kasus Di Pt. Xyz),” J. Tek. Ind. USU, vol. 1, no. 1, pp. 16–22, 2013.
Jamaluddin E.H, Rahman and K. Kadirgama, “METHOD OF PREDICTING, ESTIMATING AND IMPROVING MEAN TIME BETWEEN FAILURES IN REDUCING REACTIVE WORK IN MAINTENANCE ORGANIZATION,” Natl. Conf. Postgrad. Res., vol. li, no. October, pp. 165–175, 2009.
R. Rasjidin and I. Wahyuningrum, “Analisis preventive maintenance jig welding pada proses perakitan support assy clutch pedal untuk mobil toyota kijang innova,” Inovisi, vol. 4, no. 2, pp. 91–98., 2005.
H. A. Prabowo, I. Almahdy, and G. B. Hasibuan, “Sistem Perawatan Mesin Press,” Pasti, vol. 3, no. 1. pp. 33–44, 2010.
