Perbandingan Sensor TEV Dan Detektor RC Untuk Pengukuran Partial Discharge Pada Peralatan Tegangan Tinggi
DOI:
https://doi.org/10.55606/jtmei.v2i1.2432Keywords:
Partial discharge, TEV sensor, RC DetectorAbstract
Electrical equipment often faces various issues, with insulation problems being a major cause of failure. This article investigates the comparative effectiveness of two Partial Discharge (PD) detection methods: using Transient Earth Voltage (TEV) sensors and Resistor-Capacitor (RC) detectors. The study was conducted on a metal box with a voltage level of 6 kV. Data collected included Background Noise (BGN) and Partial Discharge Inception Voltage (PDIV), processed using Microsoft Excel and OriginPro 9. Results indicate a correlation between higher BGN values on TEV sensors and earlier PDIV occurrence on those sensors. Background noise significantly impacts the PDIV threshold, influencing sensitivity and insulation risk potential. While PDIV provides a threshold guideline, correlation with BGN helps illustrate the background conditions' influence on PD measurement outcomes. The study offers insights into the importance of considering noise in PD measurements and formulates recommendations for practitioners to choose appropriate detection methods based on specific environmental conditions and electrical equipment.
References
Dede. 2017. “Perancangan Dan Pembuatan Pendeteksi Partial Discharge Menggunakan Rangkaian Pi-Attenuator Dan Penguat Ultrawide Band.” Bandung Institute of Technology, Bandung.
Dedi Tri Laksono. 2018. “Perancangan Sensor Transient Earth Voltage Untuk Pengukuran Partial Discharge.” Bandung Institute of Technology, Bandung.
Han, Tao, Boxue Du, Yu Gao, and Yansong Xia. 2012. “Partial Discharge Pattern Recognition Based on Transient Earth Voltage for 10 KV Switchgear in Smart Grid.” Pp. 1–4 in IEEE PES Innovative Smart Grid Technologies.
Illias, Hazlee Azil. 2011. Measurement and Simulation of Partial Discharges within a Spherical Cavity in a Solid Dielectric Material.
Laksono, Dedi Tri, and Umar Khayam. 2017. “Effect of the Presence of Metal Box on Partial Discharge Waveform and Pattern Detected by High Frequency Current Transformer.” Pp. 331–34 in 2017 International Conference on High Voltage Engineering and Power Systems (ICHVEPS).
Laksono, Dedi Tri, Deni Tri Laksono, Monika Faswia Fahmi, and Umar Khayam. 2023. “Partial Discharge Measurement Using Transient Earth Voltage Sensors with Different Dimensions in Metal Shrouded Equipment.” IJSEIT (International Journal of Science, Engineering, and Information Technology ) 7(2):406–11.
Laksono, Dedi Tri, Deni Tri Laksono, and Umar Khayam. 2020. “Comparative Measurement of Partial Discharge Using Spiral Antenna with RC Detector on High Voltage Equipment.” Journal of Physics: Conference Series 1569(3):32089. doi: 10.1088/1742-6596/1569/3/032089.
Laksono Deni Tri, Laksono Dedi Tri, and Ulum Miftachul. 2021. “Spiral Antenna Design and Analysis As a Tool to Measure Partial Discharge in High Voltage Equipment.” E3S Web Conf. 328:2006. doi: 10.1051/e3sconf/202132802006.
Laksono, Deni Tri, Dedi Tri Laksono, Miftachul Ulum, and Ika Oktavia Suzanti. 2021. “10 Segment Spiral Antenna to Measure Partial Discharge on High Voltage Equipment.” IOP Conference Series: Materials Science and Engineering 1125(1):12071. doi: 10.1088/1757-899X/1125/1/012071.
Prasetya, H. 2016. “Study of Partial Discharge Measurement by Using Transient Earth Voltage Sensor.” Bandung Institute of Technology, Bandung.
Sania. 2015. “Perancangan, Pembuatan, Dan Pengetesan Rangkaian Pendeteksi Dan Pengukuran Partial Discharge Pada Frekuensi Ultrawide Band.” Bandung Institute of Technology, Bandung.
Tri Laksono, Deni, Dedi Tri Laksono, and Umar Khayam. n.d. COMPARISON OF TWO DIFFERENT DESIGNS OF PLANAR SPIRAL ANTENNA TO DETECT THE PARTIAL DISCHARGE CHARACTERISTICS IN METALLIC ENCLOSED HIGH VOLTAGE EQUIPMENT.
Xue, Cheng, Boxue Du, Tao Han, and B. X. Yang. 2012. Comprehensive Detection and Analysis of Partial Discharge in Switchgear.
