Analisis Tegangan Pada Poros Engkol Piston Dengan Material Alumunium 6061 Menggunakan Ansys 18.1
DOI:
https://doi.org/10.55606/jtmei.v2i3.2118Keywords:
Crankshaft, Ansys, Safety FactorAbstract
The crankshaft is one of the main components that works in a combustion engine as a converter of the up-and-down motion of the piston into a rotary motion against the shaft used to drive chain wheel components, gears, or other components. In the research conducted, namely the analysis of the use of materials on the crankshaft using Ansys software with the aim of knowing the stress distribution, displacement, and safety factor. conclusion where the value of the radial free force of the crankshaft is 15 N, and the data that takes place on the crankshaft as follows: Based on the results of the analysis using Ansys, the maximum stress of 0.0866 N/mm2 is obtained. The displacement that occurs using Ansys analysis is 1.3461e-03mm. The safety factor that has been analyzed is 1.5 + 10.
Downloads
References
Achmad Zainuri. (2010). Tegangan Maksimum Dan Faktor Keamanan Pada Poros Engkol Daihatsu Zebra Espass Berdasarkan Metode Numerik. Momentum, 6(2), 42–47.
Muhammad, A., Ali, M. A. H., & Shanono, I. H. (2020). Fatigue and harmonic analysis of a diesel engine crankshaft using ansys. Lecture Notes in Mechanical Engineering, 371–376. https://doi.org/10.1007/978-981-15-0950-6_56
Rohman, S. A., Okariawan, I. D. K., & Zainuri, A., 2012, Analisis Variasi Jarak Sumbu Poros Terhadap Tegangan Kontak Dan Tegangan Bending Pada Helical Gear Pair Berdasarkan Metode Elemen Hingga. Dinamika Teknik Mesin, 2(2), 84–91. Retrieved from https://media.neliti.com/media/publications/ 69189-ID-analisis-variasi-jarak- sumbuporos-terha.pdf
Rincle Garg, Sunil Baghla., Finite element analysis and optimization of the crankshaft., International Journal of Engineering and Management Research, 2(6) (2012) 26-31 ISSN: 2250-075.
S.R.Deviyaprasanth., Evaluation of Fatigue Life of the Crankshaft, International Journal of Scientific & Engineering Research, ISSN 2229-5518, 7(4)(2016)
Material Property Data (www.efunda.com). (Akses10 Juli 2010).
Prasitio Handoko. Putaran Poros Engkol dan Transmisi Poros Propeller, CV. Karya Utama, Surabaya, 2009.
Qu, Z. (2021). The Modal Analysis of the parallel bars of the crankshaft of a Mini Air Compressor on ANSYS. Journal of Physics: Conference Series, 1965(1). https://doi.org/10.1088/1742- 6596/1965/1/012151
Solanki, A., Tamboli, K., & Zinjuwadia, M. J. (2011). Crankshaft Design and Optimization- A Review. National Conference on Recent Trends in
Engineering and Technology, May, 1–5
Yu, S., Chen, R., Xu, H., & Huichao, L. (2007). Finite Element Analysis of a Stagger Crankshaft Based on ANSYS. Neiranji Gongcheng (Chinese Internal Combustion Engine Engineering), 28(2), 65–67.
